Headlines on ccie practice labWhat? Nothing to see?!?
Copywrite, Ink. on Bloggers Unite
Thu, 15 Nov 2007 01:37:26 +0000
Our good friend Rich at Copywrite, Ink. has put together an amazing video to help promote our next Bloggers Unite campaign, Acts of Kindness. We are asking bloggers around the world to take some time out from their normal day to day routine and perform an act of kindness and blog about it on December ...]
OSPF Virtual Links and Max Cost
Thu, 17 Apr 2008 01:53:09 +0000
OSPF virtual links are relatively simple to configure and you normally do not run into too many problem getting them up and working but an odd issue you could run into is when trying to run the virtual link over an interface who’s OSPF cost is maximized (65535 or 0xffff). The virtual link will not ...]
Network statements are no longer needed in OSPF configuration by Ivan Pepelnjak
Tue, 15 Apr 2008 12:24:29 +0000
A quick little interesting article, but a big change none the less.
“If you’ve ever had to configure OSPF on a Cisco router, you’re well familiar with the venerable network statement, which effectively assigns interfaces into OSPF areas based on their IP addresses. Although our life became simpler when the network statements stopped being order-dependent (the ...]
IEWB Vol.3 Lab 6 - Connect 2 Separate OSPF Backbone Areas Via Redistribution + RIP v2 Without “version 2″ Command + Multilink PPP over FR (MLPoFR)
Sat, 12 Apr 2008 20:27:57 +0000
I just finished off lab 6 in the InternetworkExpert.com volume 3 series. One odd problem was the creation of 2 physically separate OSPF backbone area. IE gave some rules stating that the backbone areas could not be joined via a virtual link on a couple of routers or a tunnel on yet ...]
Unity - Tips
Wed, 02 Aug 2006 06:58:37 +0000
The following tip may be utilized when you are asked to forward a call from CM / CME to Voicemail and have the caller leave a message. Then the message should be delivered to multiple user inboxes and also light up mwi on the appropriate phones.
a. Setup CM/CME to forward calls to VM. (say a ...]
Understanding IPv6 NAT-PT
Fri, 18 Apr 2008 18:24:18 +0000
IPv6 NAT-PT is to be used with IPv4 to IPv6 migration scenarios and it’s purpose is to provide bi-directional connectivity between IPv4 and IPv6 domains. A dual-stack router with interfaces in both IPv4 and IPv6 networks is capable of performing this task. The difference from classic IPv4 NAT is that translations should be done both ...]
Example Configurations for PPP over Ethernet (PPPoE)
Sun, 20 Jan 2008 22:20:10 +0000
Below are a couple example configurations for PPPoE. Note that you can run into MTU issues when trying to use OSPF over PPPoE. This can easily be resolved by using the “ip ospf mtu-ignore” command as the dialer interface’s MTU is 1492 while the virtual-template’s (virtual-access) MTU is 1500.
*** Client ***
interface Ethernet0/0
pppoe enable
...]
Keeping in mind the important points about ccie practice lab, we hope this article on ccie practice lab proves to be very informative to you. Use these points well.
#
ccie practice lab Products we recommend
Discount PCs, HDTVs and More at the new CompUSA.com
ccie exams
ccie expert
ccie expert
ccie home lab
ccie certified
